One thing that I do not look forward to about spring and summer, at our home, is the higher demand for water. This not only causes our water bills to go up, it also makes me feel a bit guilty of the waste that seems to take place at times. The increase in water use is due to watering flowers, watering areas of the lawn, the kids 4H project animals and so on.
Last spring I installed a rain barrel and this really helped cut down on some of our water use. But the rain
barrel basically got shut down over the winter in fear of it freezing and causing downspout freeze issues. So during the winter months the rain barrel was no help to me and my water consumption efforts.I recently ran across a few articles on what you can do to save or conserve water inside your home and found one that talked about toilets. Did you know that most toilets in the US will use over 3.5 gallons of water per flush? There are however some low flow toilets in some of our homes however they still use almost 2 gallons per flush. On average toilets account for 26% of your homes water usage, WOW!
So what can you do to help? Well one thing you could do is install a dual flush toilet. A dual flush toilet has two flush buttons, you push the #1 button if you go #1, which uses very little water, or if you go #2 then press button #2 which uses more water (for obvious reasons). This option would require you to replace your current toilet.
Another option is to adjust your tanks fill level by either adjusting the float inside your tank or using what I am recommending which is an empty one gallon milk container or two liter pop bottle. What you do here is fill the empty container with a few rocks or sand and then fill it the rest of the way with water (preferably water from your rain barrel). You then take the tank lid off of your toilet's tank (the tank is the upper part of the toilet where your flush handle is located) and place the container in the tank. Make sure that you place the container as far away from the valve or any moving parts as you can. You will need to flush the toilet to get the water to run out of it in order to get the container in without making a big wet mess. The container should sit up by itself and should not interfer with any of the moving parts inside the tank. After you verify that it is in a good upright place, put the lid back on. You now saved yourself almost a gallon of water per flush. Add that up and in a weeks time and that could be several hundreds of gallons saved!
The photo above shows what a one gallon milk jug looks like inside one of our toilets at our office. Just a quick note is to make sure your container fits into the tank before you place it in there. One of our toilets at the office would not allow a one gallon milk jug to fit without interfering with the float assembly so I had to use a two liter pop container.
Please share this with others and share any of your "Green Tips" or ideas with me.
James
